- Fits 2005-2010 Mustang GT without Engine Dress-Up Cover.
- Fits 2011-2014 Mustang GT with Engine Dress-Up Cover
- Parallel beam design for added rigidity
- Black powder coated
- Stainless steel Ford Racing emblem
- Strut Tower Brace does not fit V-6, supercharged GT, optional intake shroud, BOSS 302 or Ford Racing Intake Manifolds.
- Will clear 2011+ 5.0L Coyote engine cover in 2011+ Mustang GT vehicles.
- Note: Some factory fasteners are one time use. Please reference a Ford service manual for reuse information and correct torque specifications.
|
- Improves handling and reduces chassis flex
- Original equipment on the limited edition BOSS 302 Mustang
- Bright silver powder-coated finish adds to your clean underhood styling
- Easy installation can be done with basic hand tools in less than 15 minutes. The ends of the brace have directional arrows so you cannot put it in backwards. Just remove the two inner nuts located on each strut tower, place the strut tower brace over the existing studs, and re-install and tighten the nuts.
- Designed to clear the "taller" BOSS 302 intake manifold (M-9424-M50BR) but will therefore also clear the stock 2005-2012 Mustang GT, Bullitt and V6 intake manifolds and hoods. Will also clear the optional 4.6L 3V plastic engine cover/intake shroud (M-6949-3V). Does not fit Shelby GT500.
- Will clear the Ford Racing 4.6L 3V Intake Manifold M-9424-463V
- Will not clear the Top Mounted Twin Screw/Roots Supercharger Kits (Roush, Magnuson, Whipple, Ford Racing, Saleen, TVS, Edelbrock etc.).
|