- Fits 2005-2009 Mustang GT
- Same muffler used as standard equipment on the 2008 Mustang Bullitt
- Throatier exhaust note
- Meets 95 decibel drive-by noise standard for aftermarket exhaust systems when installed on stock applications
- Exhaust note was tuned to closely match the sound recordings from the original movie
- Aluminized T-409 stainless steel corrosion resistant body with a polished T-304
stainless tip
Muffler Installation Notes:
Install time takes less than an
hour with common wrench and ratchet/socket set. The trick to installing
any axle-back muffler setup on these cars is to unbolt the hangers from
the car and remove the stock mufflers with the hanger brackets still on
the muffler. Then you transfer the hanger brackets to the
corresponding mounts on the new muffler and install/re-fasten the
hangers and muffler back to the frame. Then repeat the process on the
muffler on the other side of the car. Finally, you will fasten the
mufflers to the respective axle pipes using the supplied clamps. These
are OEM mufflers so the fitment and weld quality are accurate and
strong.
If you try to remove/replace the mufflers by
sliding/prying the mounts out of the hanger brackets, you will bend and
damage the mufflers mounts. The hanger brackets are purposely setup in
way that the muffler mounts cannot easily work themselves free from the
hanger brackets on the car so don't try this method.