Hooker Blackheart 2011-16 Ford Mustang V6-3.7L 304SS 1-5/8" Shorty Header-Raw -- 70303302-RHKR
|
|
Hooker Blackheart 2011-2014 Ford Mustang V6, 3.7L 2.5" Race Only Down Pipe & X-Pipe without Catalytic Converter -- 70803303-RHKR
|
|
List Price:$777.95 Our Price:$699.95 You save $78.00!
|
|
|
|
|
- Performance gains of +9.23 HP and +8.33 LB.FT torque
- Constructed from 1 5/8" diameter, mandrel bent, 18-gauge 304 stainless steel tube
- Utilizes true mitered merge collectors designed to maximize exhaust velocity and scavenging resulting in a broad torque curve
- Uses 3/8" thick 304 stainless steel flanges for durability and an optimum sealing surface
- Retains factory O2 sensors and catalytic converters
- 100% bolt-on for a hassle-free installation
- Quality welds for strength, longevity and good looks
- CARB Executive Order (EO) pending
- Manufacturer's Limited Lifetime Warranty
|
- Max dyno gains of +10.04 HP & +12.39 LB.FT torque (w/ catalytic converters)
- 2.5" diameter 304 stainless steel RACE ONLY down pipes available with or without high flow catalytic converters
- An
X-Pipe is incorporated to help exhaust scavenging for optimum
performance and gives it an aggressive tone while minimizing exhaust
drone
- Quality welds for strength, longevity and good looks
- Utilizes factory mounting points for ease of installation
- Tube geometry designed for maximum ground clearance and hassle free installation
- 100%
bolt on with no modifications necessary working with either the OEM
exhaust system and OEM exhaust manifolds or Blackheart Exhaust Systems
70303302-RHKR, 70403310-RHKR, 70403311-RHKR, 70503318-RHKR OR
70503319-RHKR.
- Manufacturer's limited lifetime warranty
**NOTE: Not legal for sale or use in California. Requires PCM Tuning- Not Included
|
|
FORD RACING 2011-2014 MUSTANG V6 TOURING MUFFLER (50 STATE) -- M-5230-MV6CA
|
|
Hooker Blackheart 2011-2014 Ford Mustang V6-3.7L 304SS 1-5/8" x 2.5" Longtube Header-Raw -- 70103306-RHKR
|
List Price:$795.00 Our Price:$739.00 You save $56.00!
(1)
|
|
|
List Price:$833.95 Our Price:$749.95 You save $84.00!
|
|
|
|
|
- Fits 2011-2014 Mustang V6.
- T-304 stainless construction
- Louder, "throatier" exhaust note
- Includes mufflers with Ford Racing embossed 3.5" exhaust tip
- 50 state drive-by noise legal
- For 2005-2009 V6 Mustang see M-5230-5V6 for 2010 Mustang V6 see M-5230-MV61
- SPECIFICALLY DOES NOT NULLIFY THE EXISTING NEW VEHICLE WARRANTY.
Muffler Installation Notes: Install time takes less than an
hour with common wrench and ratchet/socket set. The trick to installing
any axle-back muffler setup on these cars is to unbolt the hangers from
the car and remove the stock mufflers with the hanger brackets still on
the muffler. Then you transfer the hanger brackets to the
corresponding mounts on the new muffler and install/re-fasten the
hangers and muffler back to the frame. Then repeat the process on the
muffler on the other side of the car. Finally, you will fasten the
mufflers to the respective axle pipes using the supplied clamps. These
are OEM mufflers so the fitment and weld quality are accurate and
strong. If you try to remove/replace the mufflers by
sliding/prying the mounts out of the hanger brackets, you will bend and
damage the mufflers mounts. The hanger brackets are purposely setup in
way that the muffler mounts cannot easily work themselves free from the
hanger brackets on the car so don't try this method.
|
- Constructed from lightweight 1 5/8"
diameter, 18-gauge, mandrel bent 304 stainless steel primary tubes w/ a 2.5" diameter outlet tube maximizing strength and performance - Feature 304 stainless steel 3/8" thick water jet flanges for strength and maximum sealing surface
- High quality O2 sensor extension wires are included
- Specifically designed to work with Blackheart race exhaust systems 70503320-RHKR or 70503321-RHKR
- Quality welds for strength, longevity and good looks
- Tube geometry designed for maximum ground clearance and hassle free installation
- Manufacturer's limited lifetime warranty
|
|
2013-2014 MUSTANG GT AXLE BACK QUAD TIP MUFFLERS WITH REAR LOWER VALENCE -- M-5230-MSVTCD
|
|
Hooker Blackheart 2011-14 Ford Mustang 3.7L V6 2.5" 304SS Cat-Back System With Mufflers -- 70503319-RHKR
|
List Price:$999.00 Our Price:$855.00 You save $144.00!
|
|
|
|
|
|
- Fits 2013-2014 Mustang GT
- 409 aluminized stainless steel corrosion-resistant muffler
body construction with twin polished 304 stainless steel 4" diameter
tips
- Mufflers are original equipment on 2013-2014 Mustang Shelby GT500
- Throatier exhaust note
- Clamp-on installation
- Shelby GT500 rear lower valence includes installation hardware
- Cutting of original lower fascia required for installation of GT500 valence
- 50 state drive-by noise legal
|
- Max dyno gains of +5.82 HP & +5.0 LB.FT torque w/muffler design
- 2.5" lightweight 18-gauge 304 stainless steel construction for maximum strength and durability
- Quality welds for strength, longevity and good looks
- Available in either a high flow, straight through muffler design or a straight through no muffler design
- 4"
dual wall, angle cut, polished 304 stainless steel tips with laser
etched Hooker Blackheart logo to add maximum styling to your ride
- Utilizes factory mounting points for ease of installation
- Tube geometry designed for maximum ground clearance and hassle free installation
- Manufacturer's limited lifetime warranty
|
|